## page was renamed from Switch
=== Config switch port ===

{{{
# ssh -l admin ca-6op290-3-swi-1
ca-6op290-3-swi-1>enable
Password: 
ca-6op290-3-swi-1#
ca-6op290-3-swi-1# show running-config
ca-6op290-3-swi-1# show config
ca-6op290-3-swi-1# show vlan

ca-6op290-3-swi-1# config terminal
ca-6op290-3-swi-1(config)# interface GigabitEthernet1/9
ca-6op290-3-swi-1(config-if)# description private network
ca-6op290-3-swi-1(config-if)# switchport access vlan 617
ca-6op290-3-swi-1(config-if)# switchport trunk native vlan 617
ca-6op290-3-swi-1(config-if)# switchport trunk allowed vlan 617,671-680
ca-6op290-3-swi-1(config-if)# switchport mode trunk
ca-6op290-3-swi-1(config-if)# end
ca-6op290-3-swi-1# show running-config
ca-6op290-3-swi-1# copy running-config startup-config
// or
ca-6op290-3-swi-1# write
}}}

=== Add Vlan ===
{{{
# vlan database
# vlan id 617
# end
# show vlan
}}}

=== Slow DHCP issue ===
It takes over 30 seconds to request the new IP from DHCP server. Add following switch port config
{{{
spanning-tree portfast [trunk]
}}}
Then it takes about 10 seconds to renew the IP from DHCP server.

=== Configure SAN Switch Zoning ===
{{{
admin> alicreate "caostest628_0", 10:00:00:90:fa:13:d4:be
admin> alicreate "caostest628_1", 10:00:00:90:fa:13:d4:bf
admin> zonecreate "z_caostest628_0", "caostest628_0; casunstor6_0; casunstor6_1"
admin> zonecreate "z_caostest628_1", "caostest628_1; casunstor6_0; casunstor6_1"
admin> cfgadd cfg_6op290, "z_caostest628_0; z_caostest628_1"
admin> cfgsave
admin> cfgenable cfg_6op290
admin> cfgshow
admin> nscamshow  //list all the switches and port wwn in the fabric
admin> fabricshow //list all the switches in the fabric and their switch ID 
}}}